Subscribe To Updates
Subscribe to our technical newsletter to be notified of bug fixes and firmware updates
Versions below require BLE version 2.0 and newer for new features. Supports all 2.X
- v2.19
- Fixed GA Station (RS485) communication issue
- v2.18
- Reduced the risk of the 4G modem entering an unrecoverable fault state
- v2.17
- Fixed issue where first SDI-12 task after a reboot was ignored
- v2.16
- Fix for repeated "Modem turn off failed" issue
- v2.15
- Increased maximum SDI-12 measurement commands to 10 (from 4), allowing for all 0-9 M! commands to be issued in one task
- Added support for Eagle 4G variant
- v2.14
- Support for Eagle 3G
- v2.13
- Added support for the individual tag update logs which are generated in v2.2 of the BLE firmware
- v2.12
- Added delta threshold to the existing analog thresholds
- v2.11
- Added scheduled uploads
- v2.10
- Added wired sending mode
- GPS aiding data fix
- v2.9
- Pulse counting anlogues are now populated after a reset
- Low battery voltage optimisations
- v2.8
- Fixed issue with periodic ble scanning where the RSSI threshold was ignored once a tag was found
- Added analogue mappings for BLE SensorNode RH sensor readings
- Integrated GA Station
- Integrated DS18B20 temperature sensor
- v2.7
- Tasks now wait until all measurements are complete before logging, instead of logging for every task action
- All outputs can now be controlled by the digital output async message
- Added async message for triggering geofence downloads
- Various optimisations
- v2.6
- Added T9602 I2C Temperature/Humidity sensor support
- Fixed 4-20mA input 2 bug
- v2.5
- Added third party server version messaging support
- Fixed issue that caused user integrated tag indentifiers to be cut short
- Added third party geofence server support
- Now sets the GPS valid flag when using default GPS position in periodic mode
- Added Bluetooth stats
- v2.4
- Compatibility hotfix for networks that don't support ePCO
- v2.3
- Added MLX90640 I2C thermal camera support
- v2.2
- Added MLX90614 I2C temperature sensor support
- Added OEM server IP address whitelisting
- Improved pulse counting functionality
- v2.1
- Added geofence support
- Added BLE fuel sensor support
- Added backup Admin parameters
- Added default latitude/longitude option for periodic mode
- Added battery capacity estimates
- Updated BLE scanning
- Fixed GPS fix on heartbeat bug
- Various small fixes
- v2.0
- Initial Release
Versions below require BLE version 1.0